P0025 Camshaft position B Code (07 C230)

mr45revolver · 05-25-2009, 10:47 PM

While driving today i noticed the check engine light came on. I immediately went over to autozone, and put there OBD on the car which resulted in a P0025 error code. After reading a few post here on the forum i found the definition for the code to be camshaft position B timing over retarded-bank 2
I have also seen a few post pertaining to the cam sensors causing the check engine light to come on. Has anyone here ran into this error code before? If so what are the potential causes. The car only has 25,000 miles on it.

To remove this ad, register today or login if you already are registered!

LILBENZ230 · 05-26-2009, 03:23 AM

2007 with 25k miles still has factory warranty, so let the dealer figure it out and keep us posted!

Glyn M Ruck · 05-26-2009, 07:57 AM

You have a camshaft position sensor on the blink. Not the ones on the front of the engine - on the side.

FrankW · 05-26-2009, 09:24 AM

you have seen a few post yet you can't search for those threads that could give you the answer you are looking for?

LILBENZ230 · 05-26-2009, 09:31 AM

I'm thinking he probably meant the issue with the M271's leaking cam sensor issues. Still, if he has factory warranty no worries.

mr45revolver · 05-26-2009, 09:38 AM

I am about 2hundred miles from my dealer. Will it hurt the car to drive that far? The check engine light has come and gone.

mr45revolver · 05-26-2009, 09:42 AM

Quote:

Originally Posted by FrankW

you have seen a few post yet you can't search for those threads that could give you the answer you are looking for?

None of those post directly addressed P0025 error code. I only found post in regards to P0012 error which sounded similar in nature. I assume there are two different codes for A, and B Postitions , but was not shure which is why i created this thread.

LILBENZ230 · 05-26-2009, 09:45 AM

Call the dealer and ask for the service department. Ask them if it's safe to drive it (I assume that it is). Then go for it. You're protected under factory warranty, there's no point in getting worked up over it.

Yeah the 200 mile trip sucks. I feel you. I'm 90 miles away and I thought that was bad.

bs79 · 07-05-2009, 03:09 AM

I have the same error code.
Have you resolved the issue? How? Thank you.

05-26-2009, 07:57 AM	#3
Glyn M Ruck MBWorld Fanatic! Join Date: Jun 2008 Location: Llandudno, Cape Town, South Africa Posts: 4,758 Drives: late 03 C240 Elegance, '65 Jaguar S Type wires	You have a camshaft position sensor on the blink. Not the ones on the front of the engine - on the side. __________________ Llandudno, Cape Town, South Africa

05-26-2009, 09:24 AM	#4
FrankW Out Of Control!! Join Date: Apr 2002 Location: Diamond Bar, CA Posts: 19,294 Drives: DirtyToo & Thrifty	you have seen a few post yet you can't search for those threads that could give you the answer you are looking for? __________________ 2002 W203 M112K with insane amount of mods "new pic on last page" 2008 W204 M272 with not so much mods. wants 307hp 7200 redline engine from SL350 For Sale:authentic Carlsson exhaust tips (2) $200

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

05-26-2009, 09:38 AM	#6
mr45revolver Newbie Join Date: Sep 2008 Location: Texas Posts: 4 Drives: 2007 c230 sport	I am about 2hundred miles from my dealer. Will it hurt the car to drive that far? The check engine light has come and gone.

07-05-2009, 03:09 AM	#9
bs79 Newbie Join Date: Nov 2007 Posts: 12 Drives: 2004 CLK 500	I have the same error code. Have you resolved the issue? How? Thank you.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)