Meth/Water/Alcohol Injection kit?

[mkonei]

totally agree....

To remove this ad, register today or login if you already are registered!

[NitrogenBalance]

Originally Posted by mkonei

not sure on the voltage setup, sorry. i had the Snow kit before, but i had it on a hobbs switch@7lbs. what is the benefit of using MAF voltage versus a boost referenced switch?

The reason that I didn't do a simple hobbs switch is that there would be no linear climb in spray. It would simply be 100% on and 100% off. I need this for more than WOT cooling. Also, in my application it is a magnacharger making only 4.5-5lbs of boost right out of idle. On a turbo that makes 20lbs of boost in a linear fashion the boost switch works perfectly. Using a boost switch for mine wouldn't do as well as the boost is pretty much on or off. No lag. Using the MAF volts you can set up the spray for a much more linear climb rather than "on" and "off".

[NitrogenBalance]

Here is a link to the system I just finished installing. Thought you might like an example

Meth/H20 installed and running great *pics*

[amx1397]

thanks ,,this helped 100% now i may put it on my car.

[bobby02c32AMG]

just thought I would add something to this old post...
From http://www.snowperformance.net/faqs_...?type=gasoline


6. Where can I mount the nozzle?
Pre- or Post- throttle body/carburetor?

• Performance: It makes almost no difference. Before or after the throttle plate(s) won’t change the effectiveness of the fluid. A given amount of fluid will absorb a given amount of heat, whether it is done more before or after the throttle plate really doesn’t matter.
• Installation: It is usually easier to inject pre-throttle body in the intake tube. Easy access, no solenoid required (unless rear-mounting a reservoir). On a carburetor, it can actually be easier to use the #40050 carb spacer plate and a #40060 solenoid for a bolt-in installation. These components are included in our RT and MC series systems.
• In a blow-through carburetor setup with an air-box enclosure around the entire carburetor, injecting after the carburetor is preferable.

Pre- or Post- Supercharger/Turbocharger?

• Centrifugal/Turbo: (Procharger, Vortech, Paxton, Powerdyne, Rotrex, etc.) Never mount an injector nozzle before a centrifugal supercharger or turbocharger compressor. Sending fluid through the compressor wheel that spins anywhere from 50,000rpm to 250,000rpm can erode the leading edges of the fine aluminum, as well as serve to reduce the atomization. Instead of a fine mist, the compressor housing will create a river of fluid along the outside wall that means we get less benefit and use more fluid.
• Positive Displacement Supercharger: Roots style (B&M, Eaton, Magnuson, etc.) or twin screw (Lysholm, Kenne Bell, Whipple, etc.) Mounting the nozzle before this style of blower is perfectly safe and actually provides some additional benefits. The small amount of water-methanol fluid isn’t harmful to any rotor seals or surfaces or coatings, and it helps to seal the clearances and condense the air some more, resulting in a more efficient output. Additionally, it keeps the rotors and housing MUCH cooler, which reduces heat transfer to the rest of the intake and air charge.


Finally getting one of these installed this week, I will update and give my impressions after its in.