You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I have a 89 300SE - driver side inside door frame has metal fatigue failure on two of the three window regulator mounting holes which caused the regulator to break off from the door frame When replacing a bad regulator on the passenger side I noted one hole doing this also but by using a large diameter washer over the original frame hole it allowed me to mount the regulator. I can probably do this on the two holes on the driver side but I'm wondering if I need a new regulator. This one is working but I am unable to removed the existing nuts off regulator without breaking the plastic spacers which are pressed on to the mounting arms of the regulator. Anyone have any ideas or has encountered this before?
Thanks,
Mike
To remove this ad, register today or login if you already are registered!
10-12-2009, 01:34 PM
Linear Mode
